ABN Bearing Puller 1/2"–4-5/8” Inch Jaw Wheel Hub Splitter Gear Pinion Separator

Description

Our eBay Store
About Us
Contact Us
Add to Favorite Sellers
ABN Bearing Puller 1/2"–4-5/8” Inch Jaw Wheel Hub Splitter Gear Pinion Separator
41.99
Smoothly separate bearings and remove gears with the ABN Bearing Puller with 1/2" to 4-5/8” Inch Jaw – Splitter Tool for Wheel Hub, Gear Pinion, Bearing Separator. There are several uses for the puller arms and it will work where other pullers fail. Use them to remove pinions and differential bearings, take off shaft bearings and gears, and successfully rebuild your vehicle’s transmission. If you want to remove a bearing, assemble the big silver plate below it, screw the black arms into the silver plate, and secure it with the nuts. Tighten with a pushing or pulling attachment (not included; uses standard SAE threads) until touching the shaft where the bearing rides until you hear a "pop" or click and the bearing will start to slide off.
Product Details
PRACTICAL DAMAGE-FREE SEPARATOR: The ABN Bearing Puller with 1/2" to 4-5/8” Inch Jaw – Splitter Tool for Wheel Hub, Gear Pinion, Bearing Separator professionally applies even pressure to smoothly separate bearings and remove gears without damage
VERSATILE USES: Removes bearings, pinions, gears, pulleys, steering wheels, and fittings from shafts; For automobiles, ATVs, and power sport vehicles
DURABLE FOR HEAVY-DUTY APPLICATIONS: Constructed from heat-treated and chrome-plated steel with a black oxide finish for rust-resistance, strength, and longevity
ADVANCED DESIGN FEATURES: Knife-like sharp angled edges on tapered bevel which are easily placed behind the part to secure a gripping surface, even when clearances are extremely limited, and gets under bearing far enough to not damage bearing when pulling; Splitter halves include SAE standard threaded holes for the acceptance of pushing or pulling attachments (not included)
SPECIFICATIONS: 4-5/8” inches maximum spread; 1/2" inch minimum spread; Approximate 5/8" inch -18 threaded holes for the push/puller; Approximate 4-3/8” inches distance between adjusting screws